LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Sport, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (1.4L 16-Valve Engine (Service Information) 500) >> Engine Mounting >> Bracket, Engine Mount, Right >> Removal >> Removal

Bracket, Engine Mount, Right: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Cover
GC0152354Courtesy of CHRYSLER GROUP, LLC
  1. Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
  2. Disconnect and isolate the negative battery cable.
  3. Remove the engine cover (1).
    Fig 2: Air Cleaner Body Assembly
    GC0152416Courtesy of CHRYSLER GROUP, LLC
  4. Remove the air cleaner body (6). Refer to BODY, AIR CLEANER, REMOVAL .
    Fig 3: Fuel Line, Hose Retainer & Fuel Vapor Purge Hose
    GC0152408Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the fuel vapor hose (3) from the intake manifold.
  6. Open the hose retainer (1). Disconnect the fuel line (2) from the fuel rail. Refer to FITTING, QUICK CONNECT .
    Fig 4: Lower Air Dam/Belly Pan
    GC0082359Courtesy of CHRYSLER GROUP, LLC
  7. Raise and support the vehicle. Refer to HOISTING .
  8. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
    Fig 5: Tunnel Support Brace & Bolts
    GC0152449Courtesy of CHRYSLER GROUP, LLC
  9. Remove four bolts (1) and the tunnel support brace (2).
    Fig 6: Rear Engine Mount Bracket, Isolator & Fasteners
    GC0153301Courtesy of CHRYSLER GROUP, LLC
  10. If equipped with a manual transmission, remove the rear engine mount bracket bolt (3) and nut (6), loosen the isolator bolt (1) and reposition the rear engine mount isolator (7) away from the bracket (5).
    Fig 7: Two Bolts Of Lower Transmission Mount
    GC0152406Courtesy of CHRYSLER GROUP, LLC
  11. If equipped with an automatic transmission, remove two bolts (4) from the rear engine mount bracket (3), loosen the bolt (1) and reposition the rear engine mount link (5) away from the bracket (3).
    Fig 8: Return Hose, Lower Supply Hose, Mounting Screw & Coolant Recovery Bottle
    GC0152348Courtesy of CHRYSLER GROUP, LLC
  12. Lower the vehicle.
  13. Reposition the coolant recovery bottle (5). Refer to BOTTLE, PRESSURIZED COOLANT, REMOVAL .
    Fig 9: Three Right Side Engine Mount Support Bolts
    GC0152565Courtesy of CHRYSLER GROUP, LLC
  14. Support the engine with a floor jack positioned under the oil pan.
  15. Remove six bolts (1 and 3) and the RH engine mount isolator (4).
    Fig 10: Upper Timing Belt Cover & Bolts
    GC0152466Courtesy of CHRYSLER GROUP, LLC
  16. Remove the bolts (2 and 3) and the upper timing belt cover (1).
    Fig 11: RH Engine Mount Bracket & Bolts
    GC0152463Courtesy of CHRYSLER GROUP, LLC
  17. Carefully raise the front of the engine and remove the six bolts (2) and the RH engine mount bracket (1).
scientia non olet · About LEMON Manuals