Switch, Power Top, Full Open Retractable Roof: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Header Panel, Electrical Connector, Power Top Switch & Clips

Courtesy of CHRYSLER GROUP, LLC

Connect the body electrical harness connector (2) to the power top switch (3).
Insert the switch into the opening in the header panel (1) and press into place until the clips (4) are fully engaged.

Fig 2: Header Panel & Dome Lamp Assembly
Courtesy of CHRYSLER GROUP, LLC
Insert the dome lamp assembly (2) into the opening in the header panel (1), and press into place.
Connect the negative battery cable.