Removal, Valve Body Wiring Harness

WARNING: This page is about a different variant/trim than selected.

Remove the Transmission Control Module (TCM). Refer to MODULE, TRANSMISSION CONTROL, REMOVAL .
Remove the transmission side cover. Refer to VALVE BODY, REMOVAL .

Fig 1: Solenoid/Speed Sensor Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness from the clamps.
Disconnect the solenoid connectors and the speed sensor connectors (1).

Fig 2: Oil Temperature Sensor, Clamp & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the oil temperature sensor bolt (1) and clamp (2). Remove the sensor (3) from the valve body.

Fig 3: Speed Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
Remove the speed sensor connector (1) from the solenoid clamp.

Fig 4: Wiring Harness Loom & Fastener
Courtesy of CHRYSLER GROUP, LLC
Remove the wiring harness loom fastener (2) and remove loom (1).

Fig 5: Connector Retaining Clip
Courtesy of CHRYSLER GROUP, LLC
Remove the wiring harness connector retaining clip (1) and remove the wiring harness from the transmission.

Fig 6: Connector, O-Ring & Gasket
Courtesy of CHRYSLER GROUP, LLC
Remove and discard the O-ring (1) and the gasket (2) from the connector.