Section 2 (Battery System (Service Information) 500 - Electric): Battery: Removal: Removal

ANY TIME BATTERY CABLE TO CLAMP NUTS ARE LOOSENED/REMOVED, THEY MUST BE REPLACED. 

Fig 1: Battery Clamp Nuts

Courtesy of CHRYSLER GROUP, LLC

1. Loosen the battery negative clamp nut (1). Disconnect the negative battery cable.
2. Loosen the battery positive clamp nut (2). Disconnect the positive battery cable.
   Fig 2: Battery Hold Down, Nut & Forward Hook

   Courtesy of CHRYSLER GROUP, LLC
3. Remove the 12 volt battery upper hold down nut (1).
4. Lift the hold down forward hook (2) out of the retainer.
5. Remove the hold down (3).
   Fig 3: Battery Hold Down

   Courtesy of CHRYSLER GROUP, LLC
6. Loosen the battery lower hold down bolt enough to allow for battery movement.
7. Remove the battery from the vehicle.