Section 94 (Charging (Service Information) 500): Generator: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Drive Belt Tensioners & Assembly With Drive Belt

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the accessory drive belt (4). Refer to BELT, SERPENTINE, REMOVAL .
Support and raise the vehicle. Refer to HOISTING .

Fig 2: Belly Pan
Courtesy of CHRYSLER GROUP, LLC
Remove the belly pan (1). Refer to BELLY PAN, REMOVAL .

Fig 3: Identifying Intermediate Shaft Support Bearing Retainer Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the right side axle shaft and intermediate shaft. Refer to REMOVAL .

Fig 4: Generator & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Disconnect the generator field wire harness connector.
Remove nut and the B+ cable from the generator stud.
Remove the top generator mounting bolt (1). This bolt is located between the generator and the A/C compressor.
Remove the bottom two generator mounting bolts (2) and the generator (3).