Sensor, Camshaft Position: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the engine cover (1).

Fig 2: Air Cleaner Body Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the air cleaner body (6). Refer to BODY, AIR CLEANER, REMOVAL .

Fig 3: PCV Hose, Bolts, Vent Hose & Oil Separator Housing
Courtesy of CHRYSLER GROUP, LLC
Disconnect the PCV hose (1) from the intake manifold.
Disconnect the vent hose (3) from the oil filler neck.
Remove three bolts (2) and remove the oil separator housing (4) from the cylinder head cover.

Fig 4: Camshaft Position (CMP) Sensor Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Unlock and disconnect the camshaft position (CMP) sensor electrical connector (1).

Fig 5: Camshaft Position (CMP) Sensor & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the mounting bolt (2) and camshaft position (CMP) sensor (1).

Fig 6: Camshaft Position (CMP) Sensor O-Ring
Courtesy of CHRYSLER GROUP, LLC
The camshaft position (CMP) sensor O-ring (1) can be reused if not damaged.