Section 33 (Rear Suspension - 500 - Except Electric): Spring(S): Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wheel Lug Bolts

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Before proceeding, refer to WARNING .

Raise and support the vehicle. Refer to HOISTING .
On both sides of the vehicle, remove the wheel mounting bolts (1), then the rear tire and wheel assembly.

Fig 2: Shock Absorber Lower Mounting Bolt, Shock Absorber Upper Mounting Bolt, Shock Absorber & Coil Spring
Courtesy of CHRYSLER GROUP, LLC
Position a transmission jack or equivalent under the center of the axle, raising it enough to support the axle.
On each side, remove the lower mounting bolt (4) securing the shock absorber to the axle.
Lower the transmission jack until the coil springs (1) can be removed from the axle.
Remove the coil springs (1) and rubber isolators.