LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Pop, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Lamps/Lighting - Exterior (Service Information) 500 - Except Electric) >> Lamp, Side Repeater >> Removal >> Bulb

Lamp, Side Repeater: Removal: Bulb

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Repeater Lamp Bulb, Socket & O-Ring
GC0153277Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the repeater lamp from the fender mounting hole. Refer to LAMP, SIDE REPEATER, REMOVAL .
  3. Firmly grasp the bulb socket (1) on the back of the lamp lens/housing and rotate it counterclockwise about 30 degrees to unlock it.
  4. Pull the socket and bulb (3) straight out from the keyed opening in the housing.
  5. Pull the base of the bulb straight out of the socket.
scientia non olet · About LEMON Manuals