Shield, Splash, Front Wheelhouse: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Access Door & Splash Shield To Fascia Fasteners

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Base model shown in illustration, other models typical unless noted.

Raise and support the vehicle. Refer to HOISTING .
Remove the splash shield to fascia fasteners (1).

Fig 2: Two Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the two fasteners (1) securing the cladding to the splash shield.

Fig 3: Three Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the three fasteners (1, 2) located forward of the wheel securing the splash shield to the vehicle.

Fig 4: Splash Shield
Courtesy of CHRYSLER GROUP, LLC
If necessary, remove the front wheel.
Remove the three remaining fasteners located at the top and rear lower areas of the splash shield (1).
Remove the splash shield (1) from the wheelhouse.