Section 14 (Audio/Video/Entertainment/Connectivity (Service Information) 500 - Electric): Radio: Installation: Installation
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the antenna connector(s) (2).
- Connect the radio electrical connectors (1).
- Insert the radio into the instrument panel until it locks into place.
- Install the radio buttons.
- Connect the 12-volt negative battery cable.
- Power up the high-voltage system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
NOTE:
The radio must be programmed after a radio replacement. Refer to STANDARD PROCEDURE .