Sensor, Park Assist: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Assist Sensor, Spacer, Bracket & Fascia

Courtesy of CHRYSLER GROUP, LLC

Engage the O-ring spacer (2) around the circumference of the sensor membrane protrusion.
NOTE:
Production and all service replacement O-ring spacers are tapered. The wide side (base) of the O-ring should be seated against the sensor housing and the narrow side should be oriented toward the outer surface of the sensor membrane and the rear fascia.
Align and insert the sensor (1) into the sensor bracket (3) behind the rear bumper fascia (4) until the bracket latch features are fully engaged over the latch tabs of the sensor.
From the back of the fascia, reconnect the wire harness connector to the sensor connector receptacle.
Perform the 12-Volt Power Up procedure. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .