Lamp, Tail Stop Turn: Removal: Bulb
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Each rear lamp unit contains either three or four bulbs. Vehicles manufactured for markets where rear fog lamps are not required have three bulbs, which are: backup, park/stop and turn signal. The rear lamp units for vehicles manufactured for markets where rear fog lamps are required have four bulbs, which are: dedicated backup in the right rear lamp unit only, dedicated park in each rear lamp unit, dedicated rear fog in the left rear lamp unit only, dedicated stop in each rear lamp unit and dedicated turn signal in each rear lamp unit. The service procedures for each bulb are the same, only the bulb sizes and types may differ.
- Disconnect and isolate the battery negative cable.
- Remove the rear lamp unit from the end of the quarter panel. Refer to LAMP, TAIL STOP TURN, REMOVAL .
- Remove the four screws that secure the socket plate to the back of the lamp housing.
- Pull the socket plate (1) straight out from the back of the lamp housing (3).
- Firmly grasp the bulb (2) and pull the base of the bulb straight out of the socket plate.