Lamp, Tail Stop Turn: Installation: Lamp
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
- Check to be certain that the two plastic ball stud grommets are in good condition and properly installed in the quarter outer panel.
- Position the rear lamp unit (2) to the lamp opening of the quarter outer panel.
- Reconnect the body wire harness connector (1) to the socket plate connector receptacle on the back of the lamp housing.
- Align the two ball studs on the outboard side of the lamp housing with the two grommets in the quarter outer panel.
- Using hand pressure, push firmly and evenly on the outboard top and bottom of the lamp until both ball studs snap into the grommets.
- Install and tighten the two screws (3) that secure the rear lamp unit to the side trough of the liftgate opening. Tighten the bolts to 27 N.m (20 ft. lbs.).
- Reconnect the battery negative cable.