LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Pop, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Lamps/Lighting - Exterior (Service Information) 500 - Except Electric) >> Lamp, Center High Mounted Stop >> Installation >> Lamp - Hatchback

Lamp - Hatchback

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: CHMSL Connector
GC0152950Courtesy of CHRYSLER GROUP, LLC
  1. Position the Center High Mounted Stop Lamp (CHMSL) (2) to the back of the liftgate upper trim cover.
  2. Install and tighten the two screws that secure the CHMSL to the back of the upper trim cover. Tighten the screws securely.
  3. Position the CHMSL and upper trim cover unit close enough to the upper inner liftgate to access and reconnect the wire harness connector (1) to the connector receptacle on the left end of the CHMSL socket plate.
    Fig 2: Center High Mounted Stop Lamp Mounting Holes
    GC0152946Courtesy of CHRYSLER GROUP, LLC
  4. Position the CHMSL and trim cover unit to the inner liftgate panel above the glass.
  5. Install and tighten the two screws that secure the trim cover and CHMSL unit to the inner liftgate panel. Tighten the screws securely.
  6. Snap the plastic covers over the two mounting holes (1) of the trim cover.
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals