Unit, Front Lamp, Lower: Installation: Lamp

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The lower front combination lamp unit combines the front park, clearance, position, Daytime Running Lamp (DRL) bulb and the turn signal lamp bulb in a single lamp unit.

Fig 1: Front Combination Lamp Unit & Screws

Courtesy of CHRYSLER GROUP, LLC

Position the lower front combination lamp unit (3) onto the back side of the front fascia.
Install and tighten the three screws (1) that secure the lamp to the fascia. Tighten the screws securely.
Reinstall the front fascia onto the vehicle. Refer to FASCIA, FRONT, INSTALLATION .
Connect the 12 volt negative battery cable.
Power up the high voltage system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .