Cover, Seat Cushion, Front: Assembly: Assembly

NOTE:

Passenger seat shown. Driver seat similar.

Fig 1: Hog Rings, Seat Bottom Cover & Seat Bottom Cushion

Courtesy of CHRYSLER GROUP, LLC

1. If necessary, install a new Occupant Detection Sensor (ODS) onto the passenger side seat bottom cushion. Refer to SENSOR, OCCUPANT DETECTION, INSTALLATION .
2. If necessary, install a new heated seat pad onto the seat bottom cushion. Refer to PAD, HEATER, INSTALLATION .
3. Position the seat bottom cover (1) onto the seat bottom cushion (3) and attach new hog rings (2).
   Fig 2: Seat Bottom Cover & Seat Bottom Cushion

   Courtesy of CHRYSLER GROUP, LLC
4. Engage the rear of the seat bottom cover (1) to the seat bottom cushion (2).
5. Install the seat bottom cushion and cover. Refer to COVER, SEAT CUSHION, FRONT, INSTALLATION  .