Lever, Parking Brake: Installation: Installation

Fig 1: Parking Brake Handle & Adjuster Nut

Courtesy of CHRYSLER GROUP, LLC

1. Place the parking brake lever (6) on the floor pan and install mounting bolts (2). Tighten the bolts to 30 N.m (22 ft. lbs.).
2. Install the rear parking brake cables into the equalizer (3) on the parking brake lever output cable.
3. Connect the wiring harness connector (2) to the parking brake switch (6).
4. Perform parking brake adjustment procedure.
5. Install the center floor console. Refer to CONSOLE, FLOOR, INSTALLATION .
6. Remove the blocks from the tires and wheel assemblies.
7. Power up the vehicle. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
8. Connect the battery negative cable to its post on the battery.