Disc, Clutch: Removal: DDCT

WARNING: This page is about a different variant/trim than selected.

Remove the transaxle from the vehicle. Refer to REMOVAL .

Fig 1: Release Bearing Retaining Clip
Courtesy of CHRYSLER GROUP, LLC
Remove the release bearing retaining clip (1) and discard.

Fig 2: Protective Cap
Courtesy of CHRYSLER GROUP, LLC
Remove the protective cap (1).

Fig 3: Release Bearing
Courtesy of CHRYSLER GROUP, LLC
Remove the release bearing.

Fig 4: Clutch Assembly Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not separate the odd gear clutch assembly.
Remove the odd gear clutch assembly bolts (1) and remove the clutch assembly.

Fig 5: Clutch Disc
Courtesy of CHRYSLER GROUP, LLC
Remove the even gear clutch disc (1).

Fig 6: Pressure Plate Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the even gear pressure plate bolts (1) and remove the pressure plate.