Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS TABLE
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Backup Lamp Switch | 38 | 28 | - | |
| Clutch cover-to-Flywheel Bolts | 25 | 18 | - | |
| Differential Ring Gear-to-Carrier Bolts | 83 | 61 | - | X |
| Flywheel-to-Crankshaft Bolts | 160 | 118 | - | |
| Gear Shaft Rear Bearing Retention Bolt | 110 | 81 | - | |
| Input Shaft Rear Bearing Retention Bolt | 56 | 41 | - | |
| Lower Mount Bracket-to-Transmission Bolts | 105 | 77 | - | |
| Pivot Bracket-to-Transmission Bolt | 147 | 108 | - | |
| Race Plate Bolts | Refer to ASSEMBLY . | |||
| Rear Transmission Mount Bracket-Lower Bolts | 20 | 15 | - | |
| Rear Transmission Mount Bracket-Through Bolt | 110 | 81 | - | |
| Reverse Idler Gear Bolt | 10 | 89 | ||
| Shift Cable Bracket-to-case Bolts | 20 | 15 | - | |
| Shift Lever Assembly-to-Case Bolts | 20 | 15 | - | |
| Shifter Assembly Mounting Nuts | 7 | - | 61 | |
| Slave Cylinder-to-Bell Housing Bolts | 10 | - | 88 | |
| Transmission Case-to-Bell Housing Bolts | 32 | 24 | - | |
| Transmission Drain/Fill Plug | 25 | 18 | - | |
| Transaxle-to-engine Bolts | 50 | 37 | - | |
| Transaxle to Engine Stud Nut, | 60 | 44 | - | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||