Solenoid, WASTEGATE: Installation: Installation

Fig 1: Wastegate Actuator Hose, Solenoid, Electrical Connector, Vacuum Supply Hose & Nut

Courtesy of CHRYSLER GROUP, LLC

1. Install the wastegate actuator (4).
2. Install the nut (5). Tighten to 8 N.m (71 in. lbs.).
3. Connect the vacuum hoses (1 & 2) and the electrical connector (3).
   Fig 2: Air Cleaner Assembly, Intake Hose, Fittings & Clamp

   Courtesy of CHRYSLER GROUP, LLC
4. Install the air cleaner assembly.
5. Connect the two vacuum fittings (4), tighten the clamp (3) at the air to turbocharger inlet tube.
6. Connect the fresh air intake hose (2).