Sunshade, Sunroof: Removal: Removal

Fig 1: Liftgate, Headliner, Door Openings & Fasteners

Courtesy of CHRYSLER GROUP, LLC

Position the sunshade in the fully open position.
Remove the headliner (2). Refer to HEADLINER, REMOVAL .
Disconnect and isolate the battery negative cable.

Fig 2: Sunshade Motor, Fasteners & Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the sunshade motor electrical connector (2) from the sunshade motor (1).
Remove the fasteners (3) from the sunshade motor (1).
NOTE:
When lowering the sunshade motor (1) be careful not to rotate it. This would cause the bowden/drive cables to move and the sunshade to be misaligned during installation.
Remove the sunshade motor (1) by lowering it straight down, releasing the drive gear from the bowden/drive cables.

Fig 3: Sunroof Motor Wiring Connectors & Wire Ties
Courtesy of CHRYSLER GROUP, LLC
Disconnect the sunroof motor wiring connectors (2 and 3).
Carefully cut the wire ties (1).

Fig 4: Sunshade, Mechanism Tubes & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the fastener (3) securing the sunshade mechanism tubes (2) to the sunroof frame.
Remove the sunshade fasteners (4) securing the sunshade (1) to the sunroof frame.
Repeat on the opposite side.

Fig 5: Bowden/Drive Cables, Sunroof Sunshade, Slides & Guides
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not allow the sunshade to become unwound in it's housing.
Carefully move the sunshade assembly (1) rearward, sliding the bowden/drive cables (4) out of the guides (3).
NOTE:
Take care not to damage the slides (2).
Remove the sunshade assembly (1) from the vehicle.