Molding, Roof Joint: Removal: Removal
NOTE:
Sunroof models typical.
NOTE:
The roof ditch molding (1) is set with body side molding tape. The temperature in the work area and the vehicle should be at least 21° C (70° F) to avoid damaging the roof ditch moldings.
- Warm the affected stick-on molding and body metal to approximately 32° C (90° F) using a suitable heat lamp or heat gun.
- Starting at one end, use a plastic putty knife or equivalent, to remove the roof ditch molding (1) from the painted surface.
- Remove adhesive tape residue from painted surface of vehicle. Use a 3M Scotch-Brite™ Molding Adhesive and Stripe Removal Discs, or equivalent, to clean adhesive residue from painted surfaces. The adhesive removal discs are available from automotive paint suppliers. Refer to instructions supplied with the discs for proper usage.