Diagnostic Test
- CHECK FOR AN INTERMITTENT CONDITION
- Turn the ignition on.
- Using the scan tool, record and erase the Radio DTCs.
- Turn the Radio on.
- Adjust the speakers to the rear and center.
- Using the scan tool, read the active Radio DTCs.
Does the scan tool read: B1408-11-REAR LEFT AUDIO SPEAKER OUTPUT - CIRCUIT SHORT TO GROUND?
Yes
- Go To 2
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK LEFT REAR SPEAKER
- Using the scan tool, erase the DTCs.
- Turn the ignition off.
- Disconnect the Left Rear Speaker harness connector from the Left Rear Speaker.
- Turn the ignition on.
- Turn the radio on.
- Using the scan tool, read the active Radio DTCs.
Does the scan tool read: B1408-11-REAR LEFT AUDIO SPEAKER OUTPUT - CIRCUIT SHORT TO GROUND?
Yes
- Go To 3
No
- Replace the Left Rear Speaker in accordance with the Service Information. Refer to SPEAKER, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE (X205) LEFT REAR SPEAKER (+) CIRCUIT FOR A SHORT TO GROUND
- Turn the ignition off.
- Disconnect the Radio C1 harness connector.
- Measure the resistance between ground and the (X205) Left Rear Speaker (+) circuit.
Is the resistance below 5.0 Ohms?
Yes
- Repair the (X205) Left Rear Speaker (+) circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 4
- CHECK THE (X295) LEFT REAR SPEAKER (-) CIRCUIT FOR A SHORT TO GROUND
- Measure the resistance between ground and the (X295) Left Rear Speaker (-) circuit.
Is the resistance below 5.0 Ohms?
Yes
- Repair the (X295) Left Rear Speaker (-) circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Radio in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Measure the resistance between ground and the (X295) Left Rear Speaker (-) circuit.