Valve, Surge: Removal: Removal

Disconnect and isolate the negative battery cable.

Fig 1: Air Cleaner Assembly, Intake Hose, Fittings & Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the two vacuum fittings (4), loosen the clamp (3) at the air to turbocharger inlet tube.
Disconnect the fresh air intake hose (2).
Remove the air cleaner assembly (1).

Fig 2: Upper Heat Shield Bolts & Nuts
Courtesy of CHRYSLER GROUP, LLC
Remove and discard the two nuts (2) and three bolts (1) that secure the upper heat shield.

Fig 3: Surge Valve, Connector & Bolts
Courtesy of CHRYSLER GROUP, LLC
Disconnect the surge valve connector (2)
Remove the three bolts (1).
Remove the surge valve (3).