Lamp, Dome: Removal: Bulb
Courtesy of CHRYSLER GROUP, LLC
- Disconnect and isolate the battery negative cable.
- Remove the dome lamp unit from the vehicle. Refer to LAMP, DOME, REMOVAL .
- If equipped, disengage the Blue And Me microphone wiring (2) from the retainer on the dome lamp back cover (1).
- Insert the tip of a small flat bladed screwdriver into the notch between the back cover and each side of the dome lamp unit housing, one side at a time.
- Gently pry the back cover inward until it unsnaps from the housing.
- Swing open the back cover to access to the dome lamp bulbs (3).
- Firmly grasp and pull the bulb straight out of the bulb holders within the dome lamp housing.