Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| (B237) PEDAL TRAVEL SENSOR FEED CIRCUIT SHORTED TO VOLTAGE |
| (B237) PEDAL TRAVEL SENSOR FEED CIRCUIT SHORTED TO GROUND |
| (B237) PEDAL TRAVEL SENSOR FEED CIRCUIT OPEN OR HIGH RESISTANCE |
| BRAKE PEDAL TRAVEL SENSOR |
| REGENERATIVE BRAKE CONTROLLER (RBC) |
WARNING:
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE . Failure to follow these instructions may result in possible serious or fatal injury.
NOTE: When performing any key-on procedure you must charge the 12 volt battery with a setting of 20 amps minimum or the High Voltage Battery could discharge below recommended manufacture specifications and destroy the battery cells.