Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

IN PLANT TEST FAILURE
1. Ignition on, engine not running.
  NOTE:
  This DTC is set when the APP Sensors are learned in plant but do not reach the Minimum or Maximum voltage range.
2. With a scan tool, select View DTCs and record the related Freeze Frame data.
3. With a scan tool, erase DTCs.
4. Start the engine.
5. With a scan tool, view DTCs.
  Is the DTC Active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
APP SENSOR RELEARN
1. With the scan tool perform the Reset Accelerator Pedal Adaptives.
2. Next, erase DTCs.
3. Start the engine.
  Does the DTC return?
  
  Yes
  - Replace the APP Sensor Assembly in accordance with the service information. After installation is complete, use a scan tool and perform the Reset Accelerator Pedal Adaptives.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST, 16V Turbo .
  No
  - Test Complete.