Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

IN PLANT TEST FAILURE
1. Turn the ignition on.
  NOTE:
  This DTC is set when the APP Sensors are learned in plant but do not reach the Minimum or Maximum voltage range.
2. With the scan tool, read DTCs.
3. With the scan tool, erase DTCs.
4. Start the engine.
5. With the scan tool, read DTCs.
  NOTE:
  Diagnose any APP Sensor out of Range and 5-Volt Supply DTCs before continuing.
  
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
APP SENSOR RELEARN
1. With the scan tool perform the Reset Accelerator Pedal Adaptives.
2. Next, erase DTCs.
3. Start the engine.
  Does the DTC return?
  
  Yes
  - Replace the APP Sensor Assembly in accordance with the Service Information. Refer to PEDAL, ACCELERATOR, REMOVAL . After installation is complete, use a scan tool and perform the Reset Accelerator Pedal Adaptives.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST, 16V Turbo .
  No
  - Test Complete.