LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2015 >> 500 Pop, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Plumbing >> Line, A/C Discharge >> Removal >> A/C Discharge Line Removal

A/C Discharge Line Removal

WARNING: This page is about a different variant/trim than selected.
WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .

  1. Remove the electric motor trim cover.
  2. Power down the high voltage system. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .
  3. Disconnect the negative 12-volt battery cable.
  4. Recover the refrigerant. Refer to STANDARD PROCEDURE  .
  5. Remove the cooling module. Refer to MODULE, A/C AND HEATER, REMOVAL .
    Fig 1: Electric A/C Compressor (EAC) Discharge Fitting Nut
    GC0157715Courtesy of CHRYSLER GROUP, LLC
  6. Remove the Electric A/C Compressor (EAC) discharge fitting nut (1), and disconnect the fitting.
    • Discard the O-ring seal.
    • Install plugs in, or tape over the opened refrigerant line fittings and ports.
    Fig 2: A/C Discharge Line Bracket Bolt
    GC0157692Courtesy of CHRYSLER GROUP, LLC
  7. Remove the LH lower A/C discharge line bracket bolt (1).
    Fig 3: A/C Discharge Line Bracket Bolt
    GC0157861Courtesy of CHRYSLER GROUP, LLC
  8. Remove the RH upper A/C discharge line bracket bolt (1).
  9. Remove the A/C discharge line.
scientia non olet · About LEMON Manuals