Cover(S), Engine Timing: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Air Cleaner Assembly, Intake Hose, Fittings & Clamp

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the air cleaner body (1). Refer to BODY, AIR CLEANER, REMOVAL .

Fig 2: Wastegate Actuator Hose, Solenoid, Electrical Connector, Vacuum Supply Hose & Nut
Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (5) and reposition the turbocharger wastegate solenoid (4).

Fig 3: Upper Timing Belt Cover, Evaporative Emissions Purge Hose, Coolant Pump Return Hose & Wastegate Solenoid Pressure Inlet Hose
Courtesy of CHRYSLER GROUP, LLC
Disengage the following retainers from the upper timing belt cover (1):
- Evaporative emissions purge hose (4).
- After run coolant pump return hose (3).
- Wastegate solenoid pressure inlet hose (2).
Fig 4: Upper Timing Belt Cover & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the bolts (2 and 3) and the upper timing belt cover (1).

Fig 5: Wheel Lug Bolts
Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle. Refer to HOISTING .
Remove the right front wheel and tire assembly. Refer to REMOVAL .

Fig 6: Right Vertical Brace, Frame Splash Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove two bolts (4) and the right vertical brace (5).
Remove two screws (2) from the front wheelhouse splash shield.
Remove three screws (1) and the frame splash shield (3).

Fig 7: Drive Belt Tensioners & Assembly With Drive Belt Routing
Courtesy of CHRYSLER GROUP, LLC
Remove the accessory drive belt (4). Refer to BELT, SERPENTINE, REMOVAL .

Fig 8: Vibration Damper & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the vibration damper (1). Refer to DAMPER, VIBRATION, REMOVAL .

Fig 9: Lower Timing Belt Cover & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (2) and the lower timing belt cover (1).

Fig 10: Side Timing Belt Cover & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (2) and the side timing belt cover (1).