Standard Procedure - Parking Brake Adjustment
WARNING: This page is about a different variant/trim than selected.
- Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL .
- Place the parking brake handle (5) in the completely lowered position.
- Back the adjuster nut (4) off until there is no tension on the parking brake cable.
- Tighten the adjuster nut (4) until tension begins to be felt on the cables.
- Look under vehicle and ensure that the parking brake actuating lever (1) has not lifted off of the parking brake stop (2) on both sides of the vehicle.
- If lever is off of the stop, it will be necessary to go back inside the vehicle and loosen the adjuster nut.
- Once there is tension on the parking brake cables and both actuating levers are still on their resting tabs, actuate the parking brake to ensure that it is functioning properly.
- Install the floor console. Refer to CONSOLE, FLOOR, INSTALLATION .