LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2015 >> 500 Pop, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Base Brakes (Service Information) 500 - Electric) >> Hydraulic/Mechanical >> Rotor, Brake >> Removal >> Rear Brake Rotor

Rear Brake Rotor

WARNING: This page is about a different variant/trim than selected.
NOTE:

Before proceeding, refer to CAUTION  and WARNING  .

  1. Raise and support the vehicle. Refer to STANDARD PROCEDURE .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
    Fig 1: Parking Brake Caliper, Actuator Arm & Guide Pin Bolts
    GC0158581Courtesy of CHRYSLER GROUP, LLC
  3. While holding the hex fitting on the caliper slides, remove caliper guide pin bolts (3).
  4. Remove caliper from mounting bracket and support with a bungee cord or wire. Do not let it hang from the brake hose.
  5. Remove caliper bracket mounting bolts (4) and remove caliper mounting bracket.
    Fig 2: Wheel Mounting Pins
    GC0152557Courtesy of CHRYSLER GROUP, LLC
  6. Remove retaining studs (1) and slide brake rotor off the hub and bearing.
scientia non olet · About LEMON Manuals