LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500c Abarth >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Aw60T Automatic Transmission (Service Information) 500 & 500C) >> Cable, Shift >> Adjustments >> Adjustments >> Verification

Cable, Shift: Adjustments: Adjustments: Verification

WARNING: This page is about a different variant/trim than selected.
  1. Place gearshift lever in gated park (P).
  2. Attempt to move vehicle by rocking back and forth on level ground. If vehicle does not move, attempt to start engine. If engine starts, the park position is correct.
  3. Set parking brake.
  4. Turn key to on/run and depress brake pedal. Place gearshift lever in neutral (N).
  5. Attempt to start engine. If engine starts in both neutral (N) or park (P), gearshift cable is adjusted properly. No adjustment is required.
  6. If engine does not start in either park (P) or neutral (N), perform adjustment procedure. Refer to CABLE, SHIFT .
scientia non olet · About LEMON Manuals