Cover(S), Engine Timing: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Side Timing Belt Cover & Bolt

Courtesy of CHRYSLER GROUP, LLC

Install the side timing belt cover (1) with bolt (2) tightened to 25 N.m (18 ft. lbs.).

Fig 2: Lower Timing Belt Cover & Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the lower timing belt cover (1) with bolt (2) tightened to 9 N.m (80 in. lbs.).

Fig 3: Vibration Damper & Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the vibration damper (1). Refer to DAMPER, VIBRATION, INSTALLATION .

Fig 4: Drive Belt Tensioners & Assembly With Drive Belt Routing
Courtesy of CHRYSLER GROUP, LLC
Install the accessory drive belt (4). Refer to BELT, SERPENTINE, INSTALLATION .

Fig 5: Right Vertical Brace, Frame Splash Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the frame splash shield (3) with three screws (1).
Install two screws (2) to the front wheelhouse splash shield.
Install the right vertical brace (5) with two bolts (4) tightened to 45 N.m (33 ft. lbs.).

Fig 6: Wheel Lug Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the right front wheel and tire assembly. Refer to INSTALLATION .

Fig 7: Upper Timing Belt Cover & Bolts
Courtesy of CHRYSLER GROUP, LLC
Lower the vehicle.
Install the upper timing belt cover (1) with two bolts (2 and 3) tightened to 9 N.m (80 in. lbs.).

Fig 8: Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
Install the engine cover (1).