With Automatic Transmission

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Hoist & Load-Leveling Lifting Sling

Courtesy of CHRYSLER GROUP, LLC

Remove the engine and transmission from the vehicle. Refer to REMOVAL .

Fig 2: Starter Assembly, Connector & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the starter assembly (5). Refer to STARTER, REMOVAL .

Fig 3: Flexplate & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the transmission and flexplate (1) from the engine. Refer to FLEXPLATE, REMOVAL .

Fig 4: Transmission Adapter Plate & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove three bolts (3 and 4), one bolt and nut (2) and the transmission adapter plate (1).

Fig 5: Oil Viscosity Sensor & Connector
Courtesy of CHRYSLER GROUP, LLC
Drain the engine oil. Refer to OIL - STANDARD PROCEDURE .
Remove the viscosity sensor (2). Refer to SENSOR, OIL VISCOSITY, REMOVAL .

Fig 6: Blocker Plate & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove two bolts (2) and the blocker plate (1) from the oil pan.

Fig 7: Oil Pan Flange Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove fourteen bolts (1), two nuts and two studs (2) from the flange of the oil pan.
Using the four indicated pry points, carefully remove the oil pan.

Fig 8: Seal Retainer Attaching Screws & Seal Retainer
Courtesy of CHRYSLER GROUP, LLC
Remove the six seal retainer attaching screws (1).
Remove and discard the seal retainer (2).

Fig 9: Oil Pan Sealant Locations
Courtesy of CHRYSLER GROUP, LLC
Remove all residual sealant (1) from the oil pan, engine block and oil pump. Refer to PAN, OIL - CLEANING .