LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500c Abarth >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Electronic Power Steering (EPS) Module - Electrical Diagnostics - 500E) >> Diagnosis And Testing >> C1005-86-Status Lamp Failure BCM - Signal Invalid >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE 

  1. Ignition on, engine not running.
  2. With the scan tool, read DTCs and record on vehicle work order.
  3. With the scan tool, erase DTCs.
  4. Start the engine and run for two minutes.
  5. With the scan tool, read DTCs.

    Is the DTC active at this time?

    Yes 

    • Replace the Instrument Panel Cluster (IPC) in accordance with service information. Refer to REMOVAL .
    • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

    No 

    • The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and electrical connectors.
    • Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST  .
scientia non olet · About LEMON Manuals