LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500c Abarth >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Base Brakes - (Service Information) - 500E) >> Hydraulic/Mechanical >> Rotor, Brake >> Removal >> Rear Brake Rotor

Rear Brake Rotor

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Before proceeding, refer to WARNING  and CAUTION  .

  1. Raise and support the vehicle. Refer to STANDARD PROCEDURE .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
    Fig 1: Parking Brake Caliper, Actuator Arm & Guide Pin Bolts
    GC0158581Courtesy of CHRYSLER GROUP, LLC
  3. While holding the hex fitting on the caliper slides, remove caliper guide pin bolts (3).
  4. Remove caliper from mounting bracket and support with a bungee cord or wire. Do not let it hang from the brake hose.
  5. Remove caliper bracket mounting bolts (4) and remove caliper mounting bracket.
    Fig 2: Retaining Studs
    GC0152557Courtesy of CHRYSLER GROUP, LLC
  6. Remove retaining studs (1) and slide brake rotor off the hub and bearing.
scientia non olet · About LEMON Manuals