LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500c Abarth >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (On-Board-Charging Module (OBCM) - Electrical Diagnostics - 500E) >> Diagnosis And Testing >> P1A24-EVSE Ac Contact Fault >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK EVSE CHARGING CAPABILITY 
    1. Connect the customers EVSE charging unit to the vehicle. Using the Scan Tool, Monitor the AC output.

      Is the EVSE charging unit operating correctly?

      Yes 

      • Advise the customer that the problem may be with their power source connection for the EVSE charging unit.
      • Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Go To  2
  2. CHECK EVSE CHARGING UNIT 
    1. Refer to the EVSE User manual information and follow the troubleshooting guide to determine if the problem is with the EVSE charging unit or the vehicle.
    2. Using the Scan Tool, Monitor the AC output.

      Is the EVSE charging unit operating correctly?

      Yes 

      • The issue that caused the DTC to set is no longer present, test complete.
      • Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Replace the EVSE charging unit in accordance with the service information.
      • Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals