LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500c Abarth >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Body Control Module (BCM) - DTCS B226A-00 To U1493-00 - 500E) >> Diagnosis And Testing >> B2778-09-Fuel Shutoff Control - Component Failures >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.

INFORMATIONAL DTC 

NOTE:

This is an informational DTC and may set if the ORC module determined an event occurred requiring FPS activation. Prior to diagnosing this DTC, repair all other DTCs or repair the vehicle as necessary.

  1. Turn the ignition on.
  2. With the scan tool, record and erase DTCs.
  3. Wait 30 seconds.
  4. With the scan tool, read DTCs.

    Does the scan tool display this DTC as active?

    Yes 

    • If the scan tool still displays this DTC as active after all other repairs have been completed, replace the BCM in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
    • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

    No 

    • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
    • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals