Diagnostic Test

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.

INTERMITTENT CONDITION
NOTE:
Prior to diagnosing this DTC, verify the Front Wiper Arm and Linkage is free of obstructions and correctly attached to the Front Wiper Motor output shaft. Repair as necessary.
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the Front Wiper on.
4. Wait 10 seconds.
5. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE FRONT WIPER MOTOR FOR CORRECT OPERATION
1. Turn the ignition off.
2. Remove the Front Wiper Arm.
3. Turn the ignition on.
4. Turn the Front Wiper on.
5. Wait 10 seconds.
6. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Repair or replace the Front Wiper Motor in accordance with the Service Information. Refer to MOTOR, WIPER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Front Wiper Arm in accordance with the Service Information. Refer to ARM, WIPER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .