Diagnostic Test

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, record and erase BPCM DTCs.
3. Turn the ignition off. Wait one minute.
4. Turn the ignition on. Wait one minute.
5. With the scan tool, read DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
CONFIGURE THE BPCM TO THE VEHICLE
1. With the scan tool, program the BPCM to the vehicle configuration.
2. With the scan tool, erase BPCM DTCs.
3. Turn the ignition on. Wait one minute.
4. With the scan tool, read DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Replace the High Voltage Battery Pack in accordance with the Service Information. Refer to BATTERY, HIGH-VOLTAGE, REMOVAL .
  - Perform the BATTERY PACK CONTROL MODULE (BPCM) VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair is complete.