Diagnostic Test
WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.
POWER INVERTER MODULE
- Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Look for any chafed, pierced, pinched or partially broken wires.
- Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact.
- Perform any Technical Service Bulletins that may apply.
Were there any problems found?
Yes
- Repair as necessary.
- Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Replace the Power Inverter Module (PIM). Refer to MODULE, POWER INVERTER (PIM), REMOVAL .
- Perform the EVCU VERIFICATION TEST. Refer to STANDARD PROCEDURE .