LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500c Abarth >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Electronic Control Modules - (Service Information) - 500E) >> Standard Procedure >> Program The CTM (Convergence Telematics Module)

Program The CTM (Convergence Telematics Module)

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.

When replacing any module not the replacement and programming order, refer to MODULE REPLACEMENT AND PROGRAMMING ORDER GUIDE  .

After verifying the proper replacement and programming order, follow the steps below to program the CTM.

  1. Connect the scan tool.
  2. Check vehicle for DTCs.
  3. Clear all stored DTCs.
  4. Turn car OFF then ON and confirm DTCs are gone.
  5. Go to CTM >> Misc. Functions >> Proxi Alignment

If required, continue to programming the next module.

scientia non olet · About LEMON Manuals