Pick-Up, Oil Pump: Installation: Installation

Fig 1: Oil Pump O-Ring Seal

Courtesy of CHRYSLER GROUP, LLC

1. Lightly lubricate the new O-ring seal (1) with engine oil and install on the oil pump.
   Fig 2: Oil Pick-Up Tube & Bolts

   Courtesy of CHRYSLER GROUP, LLC
2. Install the oil pick-up tube (1) with two bolts (2). Tighten the bolts to 10 N.m (89 in. lbs.).
3. Install the oil pan. Refer to PAN, OIL, INSTALLATION .
4. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to OIL - STANDARD PROCEDURE  .
5. Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
6. Run the engine until it reaches normal operating temperature.