Diagnostic Test

CHECK IF THE DTC IS ACTIVE 

1. Turn the ignition on.
2. With the scan tool, read DTCs.

   Does the scan tool display this DTC as active?

   Yes 

   • Replace the Instrument Panel Cluster (IPC) in accordance with the Service Information. Refer to REMOVAL .
   • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

   No 

   • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
   • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .