Pan, Oil: Removal: Removal

Remove the engine and transmission from the vehicle. Refer to REMOVAL .
Remove the transmission from the engine (Refer to C635 DDCT AUTOMATIC TRANSMISSION - SERVICE INFORMATION - 500L - Removal ).

Fig 1: Starter Assembly, Connector & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the starter assembly (5). Refer to STARTER, REMOVAL .

Fig 2: Flexplate & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the flexplate (1) .

Fig 3: Transmission Adapter Plate & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove three bolts (3 and 4), one bolt and nut (2) and the transmission adapter plate (1).
Drain the engine oil. Refer to OIL, STANDARD PROCEDURE .

Fig 4: Oil Pan Flange Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove fourteen bolts (1) and two nuts (2) from the flange of the oil pan.
Using the four indicated pry points, carefully remove the oil pan.
Remove all residual sealant from the oil pan, engine block, oil pump and rear seal retainer. Refer to PAN, OIL, CLEANING .

Fig 5: Oil Pan Sealant Locations
Courtesy of CHRYSLER GROUP, LLC
Remove all residual sealant (1) from the oil pan, engine block, oil pump and rear seal retainer. Refer to PAN, OIL, CLEANING .