When Monitored
WARNING: This page is about a different variant/trim than selected.
Ignition key is in ACC position or the TCM control unit is in power-on state. The engine is not in cranking mode.
Power supply must be between 7 volts and 24 volts and Main Micro Processor (MMP) supply diagnostics have not failed.
The Sensor Power Supply 3 (VS3) to the Hydraulic Pressure Sensor has not failed.
The transmission fluid temperature value is greater than a calibrated value and it has no electrical failure.
The Hydraulic Pressure Sensor has no electrical failure.
Internal Control Module A/D Diagnostic has not failed.