When Monitored
WARNING: This page is about a different variant/trim than selected.
Ignition key is ON or the TCM control unit is in power-on state. The engine is not in cranking mode.
Power supply must be between 7 volts and 24 volts and Main Micro Processor (MMP) supply diagnostics have not failed.
The Hydraulic Pressure Sensor Diagnostics have not failed and the hydraulic pressure sensor value is greater than a minimum value.
The Even Clutch Pressure Sensor Diagnostic has no electrical failure.
The 5v Supply B (VS2) to the K2 Pressure Sensor has not failed.
Internal Control Module A/D Diagnostic has not failed.