When Monitored
WARNING: This page is about a different variant/trim than selected.
Enable Conditions for Check 1
This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the transmission is shifting and the target gear is the 3rd gear.
Enable Conditions for Check 2
This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the transmission is shifting and the target gear is the 2nd gear.
Enable Conditions for Check 3
This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the transmission is shifting and the target gear is the Reverse gear.