Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK TO SEE IF DTC P0716 IS CURRENT
1. Using the scan tool, read TCM DTCs.
2. Record the Environmental Data and any DTCs.
3. Clear DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. Read TCM DTCs.
  Did the DTC reset?
  
  Yes
  - Go To 2
  No
  - Go To 5
CHECK FOR OTHER SENSOR DTCS
1. Using the scan tool, read TCM DTCs.
  Are there other sensor or sensor power supply DTCs set?
  
  Yes
  - Check the (F895) 5 Volt Supply C circuit for an open or short to ground. If no problem is found, and using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information.
  - Perform the C635 DDCT TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK (T13) ODD SPEED SENSOR SIGNAL CIRCUIT FOR AN OPEN OR SHORT TO GROUND
1. Turn the ignition off to the lock position.
2. Disconnect the TCM C2 harness connector.
3. Disconnect the Odd Speed Sensor harness connector.
4. Check the (T13) Odd Speed Sensor Signal circuit for an open or short to ground.
  Was an open or short to ground found?
  
  Yes
  - Repair the (T13) Odd Speed Sensor signal circuit for an open or short to ground.
  - Perform the C635 DDCT TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 4
CHECK THE (T191 AND T192) SENSOR GROUND CIRCUITS FOR AN OPEN
1. Measure the resistance of the (T191 AND T192) Sensor Ground circuit between the Odd Speed Sensor and the TCM C2 harness connector.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Replace the Odd Speed Sensor.
  - Perform the C635 DDCT TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the (T191 or T192) Sensor Ground circuit for an open.
  - Perform the C635 DDCT VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
4. With the scan tool, check the Event Data to help identify the conditions in which the DTC was set.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the C635 DDCT TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test Complete.